Dust, moisture and pollutants build up inside fresh-air ducts over time, lowering indoor air quality and raising the load on your HVAC system. Shiny inspects, cleans and disinfects the full network with camera-verified results.
We inspect, vacuum and clean the ducts that pull in and distribute outside air, using inspection cameras and negative-pressure equipment to remove build-up without spreading dust indoors.
Every job is documented with before/after camera footage, so you have a clear record of the work performed.
Fresh-air systems pull in outside air and distribute it throughout the building — without regular inspection, dust and moisture accumulate inside.
A camera-verified, documented clean of your entire fresh-air network.
Specialised cameras survey the interior of the ducts, locating build-up and shaping the right work plan before cleaning starts.
Equipment sized to duct dimensions and design breaks down and removes build-up from interior surfaces.
High-power vacuum and negative-pressure systems pull loosened dust away, preventing it from spreading indoors during the clean.
Cleaning intake grilles, outlets, and diffusers connected to the system according to the agreed scope of work.
Fans and distribution boxes that accumulate dust are cleaned after inspection determines the right approach.
Once cleaning is complete, a sanitization stage is available using materials safe for ventilation systems, based on site needs.
A nine-step process built around inspection, containment and documentation.
Our team surveys the site and ventilation system, mapping duct routes, access points and usage patterns.
Ducts are inspected from the inside with specialised cameras to detect build-up levels and areas needing extra attention.
Nearby areas are covered and protected, and the required sections are isolated to limit dust reaching interior spaces.
High-power vacuum units connect to the ducts, drawing dust and particles toward collection units instead of the building.
Mechanical brushes and specialised tools reach interior surfaces and break down accumulated build-up.
Loosened dust and particles are extracted with filtration systems that capture what's collected.
If inspection shows the ducts need disinfecting, suitable materials are applied per safety and usage guidelines.
Once cleaning is done, ducts are inspected again to confirm build-up is removed and agreed work is complete.
Isolated sections are reopened and the system restarted, then you receive a full report with before/after footage, findings, and maintenance recommendations.
Vacuum units, negative-pressure systems, mechanical brushes and inspection cameras that reach every part of the network.
We document duct condition before the work starts and the results afterward, so you have a clear picture of what was done.
Isolating work areas and using vacuum and negative pressure keeps dust from spreading through the building.
Technicians trained on ventilation ductwork and cleaning equipment, applying the right safety measures for each site.
Work can be scheduled during off-peak hours to minimise the impact on daily operations.
Work plans sized to facility area and duct network length, with the option to phase larger projects.
It's cleaning the interior surfaces of the ducts responsible for pulling in and distributing outside air, using tools that break down and vacuum out dust and residue.
AC cleaning typically focuses on the units, filters and coils, while duct cleaning targets the network that carries and distributes air through the building. Some facilities need both.
It helps remove dust, residue and some odor sources inside ducts. If the odor comes from a water leak or drainage issue, that root cause needs separate attention.
Ducts can be sanitized after cleaning when needed, using materials suited to the ventilation system and site requirements, determined after inspection.
Work can be phased and scheduled during off-peak hours to reduce impact on daily operations, depending on network size and site nature.
Yes, duct condition can be documented with inspection cameras, with photos and notes included in the technical report provided to the client.
Yes, Shiny offers recurring inspection and cleaning programs suited to commercial, industrial and administrative facilities based on activity and duct network size.
Duct cleanliness isn't just about appearance — it's a core part of building efficiency and workplace quality. Request a fresh-air duct inspection from Shiny and get a technical assessment and cleaning plan sized to your facility.
